Mitsubishi 3000GT VR4 Dodge Stealth RT Turbo Fuel Pump Assembly Old Part # MB678807

⚠️ Limited Production Run — No restock after remaining 7 units sell out.

Following a multi-year development, V12Throttle Corp is proud to present a new complete fuel pump assembly for the 1991–1999 Mitsubishi 3000GT VR4 / Dodge Stealth RT Twin Turbo. Plug-and-play installation with several upgrades while retaining OEM form, reliability, and function.

Only the highest quality components were used — high-grade coated steel, PTFE wiring, and Teflon rubber. This pump underwent thousands of miles of real-world testing before release.

📦 What's Included

• Complete fuel pump assembly (drop-in replacement)
• Upgraded turbo pump motor (carbon commutators)
• Pre-installed OEM plug-in wiring harness
• Top rubber seal (pre-installed)
• Fuel level sender unit
• High-grade coated steel housing

🔌 Connector & Fitting Details

• Wiring connector: OEM plug-in style — direct replacement, no splicing required
• Wiring insulation: PTFE (high-heat, fuel-resistant)
• Fuel line fittings: OEM-matched inlet/outlet ports
• Seal material: Teflon rubber top seal

🚗 Fitment by Model & Year

⚠️ Fits TURBO models only. Not compatible with naturally aspirated (NA) variants of either vehicle.

Supersedes OEM Part #: MB678807

⚡ Electrical Requirements

• Operating voltage: 12–14.5V DC
• Design voltage (spec point): 13.5V
• Current draw: Similar to OEM stock unit — will not overload or burn out the fueling circuit relay
• Connector type: OEM plug-in (no relay upgrade required)

📊 Flow & Pressure Specifications

• Flow rate: 185 lph @ 43 psi / 13.5V (under boost)
• Stock unit flow rate: ~160 lph (this is an upgrade)
• Operating pressure: 43 psi
• Operation: Quiet — designed to match OEM noise levels

🔧 Installation Assumptions

• Direct plug-and-play replacement for OEM assembly — no cutting, splicing, or adapter required
• Assumes stock fuel tank, sending unit location, and unmodified fuel circuit relay
• Compatible with factory fuel pressure regulator
• Standard removal of fuel tank access panel required (refer to FSM for procedure)
• Recommended to drain or lower fuel level before removal for easier handling

✅ Buyer Verification Checklist

Before ordering, confirm the following:

• Your vehicle is the twin-turbo variant (VR4 or RT Turbo) — not the NA or SOHC model
• Your OEM part number matches or supersedes MB678807
• Your fuel circuit relay and wiring are in working condition (pump will not compensate for a failed relay)
• Your fuel tank is free of debris or contamination (a contaminated tank will damage any new pump)
• You are using compatible fuel (gasoline — not flex/E85 unless confirmed with V12Throttle)